> Physical Port

> 8-port 10/100/1000BASE-T with 36W PoE injector function

> 2-port 1G/2.5G/10G BASE-X SFP+

> RS232 RJ45 console interface for switch basic management and setup

> Power over Ethernet

> Up to 8 ports of IEEE 802.3af/802.3at devices powered

> Supports PoE power up to 36 watts for each PoE port

> Auto detects powered device (PD)

> Circuit protection prevents power interference between ports

> Remote power feeding up to 100 meters

> PoE Management

> PoE admin-mode control

> PoE usage threshold

> Temperature threshold

> PoE Port Status monitoring

> PD classification detection

> Per port PoE function enable/disable

> Per PoE port power limit

> PoE Port Power feeding priority

> PoE extend mode control to support power feeding up to a distance of up to 200 meters

> Intelligent PoE features

> Temperature threshold control

> PoE usage threshold control

> PD alive check

> PoE schedule

> Layer 3 IP Routing Features

> IP dynamic routing protocol supports RIPv2, OSPFv2 and OSPFv3

> IPv4/IPv6 hardware static routing

> Routing interface provides per VLAN routing mode

> Layer 2 Features

> High performance of Store-and-Forward architecture and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth

> Storm Control support

> Broadcast/Multicast/Unknown unicast

> Supports VLAN

> IEEE 802.1Q tagged VLAN

> Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)

> Private VLAN Edge (PVE)

> Protocol-based VLAN

> MAC-based VLAN

> Voice VLAN

> GVRP(GARP VLAN Registration Protocol)

> Supports Spanning Tree Protocol

> IEEE 802.1D Spanning Tree Protocol

> IEEE 802.1w Rapid Spanning Tree Protocol

> IEEE 802.1s Multiple Spanning Tree Protocol, spanning tree by VLAN

> BPDU Guard

> Supports Link Aggregation

> 802.3ad Link Aggregation Control Protocol (LACP)

> Cisco ether-channel (static trunk)

> Maximum 5 trunk groups, up to 2 ports per trunk group

> Up to 40Gbps bandwidth (full duplex mode)

> Provides port mirror (many-to-1)

> Port mirroring to monitor the incoming or outgoing traffic on a particular port

> Loop protection to avoid broadcast loops

> Link Layer Discovery Protocol (LLDP)

> Compatible with Cisco uni-directional link detection(UDLD) that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices

> Supports G.8032 ERPS (Ethernet Ring Protection Switching)

> Quality of Service

> Ingress Shaper and Egress Rate Limit per port bandwidth control

> 8 priority queues on all switch ports

> Traffic classification

> IEEE 802.1p CoS

> TOS/DSCP/IP Precedence of IPv4/IPv6 packets

> IP TCP/UDP port number

> Typical network application

> Strict priority and Weighted Round Robin (WRR) CoS policies

> Supports QoS and In/Out bandwidth control on each port

> Traffic-policing policies on the switch port

> DSCP remarking