Planet DCS-7342-32C Layer 3 Managed Data Center Switch 32x 100G QSFP28

> Physical Ports

> ．32-Port 100G/40G QSFP28 interfaces (Port-1 to Port-32)

> ．RJ45 to DB9 console port for switch basic management and setup

> ．1-port 10/100/1000T RJ45 Management Port

> ．1 x USB 2.0 Type A for USB storage device (Configuration backup and restore)

> Switching

> ．Features Store-and-Forward mode with wire-speed filtering and forwarding rates

> ．IEEE 802.3x flow control for full duplex operation and back pressure for half duplex operation

> ．10K jumbo frame

> ．128K MAC Address Table Size

> ．24MB Shared Data Buffer

> ．Supports ESD Protection

> ．．Contact Discharge 4KV DC

> ．．Air Gap Discharge 8KV DC

> ．Automatic address learning and address aging

> ．Support CSMA/CD protocol

> Stacking Features

> ．Connects with stack member via 100G QSFP28 interfaces

> ．Single IP address management, supporting up to 8 units stacked together

> ．Virtualized multiple PLANET`s DCS-7342-32C data center switch devices stacked into one logical device

> IP Routing Features

> ．IPv4/IPv6 hardware static routing

> ．IPv4 dynamic routing protocols such as RIPv1/v2, OSPFv2, IS-IS and BGP

> ．IPv4 Route policy/IPv4 Policy-based routing

> ．IPv6 dynamic routing protocols such as RIPng, OSPFv3, IS-ISv6 and BGP4+

> ．IPv6 Route policy

> ．Ethernet Virtual Private Network (EVPN)

> ．Multiple tunneling techniquesGRE Tunnel, VXLAN, VRF and ECMP

> ．BFD session binding static routes, VRRP, OSPF, BGP and RIP

> Multicast Routing Features

> ．IPv4 IGMP v1/v2/v3

> ．Support PIM-SM (Protocol Independent Multicast–Sparse Mode) and PIM-SSM ((Protocol Independent Multicast

> ．．Source-Specific Multicast), PIM-DM (Protocol Independent Multicast – Dense Mode)

> ．IPv6 MLD v1/v2 and MLD v1/v2 Snooping

> ．Support Multicast VLAN Registration for IPv6

> ．Support PIM-SM v6 (Protocol Independent Multicast-Sparse Mode IPv6)

> Layer 2 Features

> ．Support VLAN

> ．Support VXLAN Layer 2 Switching, Routing Switching, and Layer 3 GRE Tunnel

> ．Support BGP EVPN

> ．Support Priority Flow Control (PFC)

> ．Support Link Aggregation

> ．．IEEE 802.3ad Link Aggregation Control Protocol (LACP)

> ．．Cisco ether-channel (static trunk)

> ．Multi-Chassis Link Aggregation (MLAG)

> ．．Basic configuration

> ．．Blackhole flow protection

> ．．MLAG VRRP

> ．．MLAG dual active

> ．Support 802.1D STP, 802.1w RSTP and 802.1s MSTP

> ．．BPDU Protection

> ．．Root Protection

> ．．Loop Protection

> ．．Anti TC-BPDU Attack

> ．Support L2-L4 packet filtering

> ．．Filters based on MAC, IP, port, protocol, IP ToS, 802.1p priority, VLAN ID, SVLAN ID, VLAN range, etc

> ．Support Multi-layer ring protection protocol (MRRP)

> ．Support Device Link Detection Protocol

> ．Support Bridge Protocol Filter

> ．Support Uplink Line Protection Protocol

> ．Loop detection to avoid broadcast loops

> ．Support port mirroring, flow mirroring, remote mirror, multi-destination, CPU mirror source/destination and

> ．ERSPAN

> ．Link Layer Discovery Protocol (LLDP)

> ．Compatible with Cisco uni-directional link detection(UDLD) that monitors a link between two switches and blocks

> ．the ports on both ends of the link if the link fails at any point between the two devices